GKtech S14/S15 Chassis Front Drop Knuckles - Grip version
is back-ordered. We will ship it separately in 7 to 15 days.
S-Chassis Front Drop Knuckle (Grip Version)
Gktech have three different variants of their world-renowned S Chassis Front Drop Knuckles!
The Grip knuckles have been specifically designed for Grip/ Time-Attack racing in mind, they have lowered the balljoint height 50mm for roll center correction while also lowering the steering mount 64mm for bump steer correction.
They have kept the OEM ackerman and OEM steering arm length, in the factory positioning.
- S13/ S14 variations (Please Specify)
- Ball joint height lowered 50mm
- Steering mount lowered 64mm
- Lightweight (S13 version is 3.1kg and S14/S15 is 3.2kg)
- Provision for ABS sensor
- Light weight
- Robust design
- 4130 Chromoly
- CMM measured, CAD designed and FEA tested
- E-coated (Electrophoresis Coating)
NOTE: Due to the 64mm of bump steer correction some tie rods may interfere with the inside of your rim. This is entirely dependent on both the inside diameter of the rim and the length/type of tie rod that you are running however as a general rule a 17" rim or larger will be required.
Available also is the GKTech hybrid of the Grip/Drift knuckle and the Pro Drift knuckle.
What's so good about drop knuckles?
A lot of people think that the best thing about knuckles (aka uprights) is getting more steering angle to drift however the main advantage of installing knuckles is the roll centre correction and bump steer correction. Extremely lowered vehicles typically handle poorly, with drop knuckles like these installed the handling will improve dramatically.
The reasoning behind that is as your lower control arm and castor (aka tension) rods are sitting near horizontal, this now brings them back to where they were before the car was lowered, which is exactly what you want for optimum handling.
Are there any modifications required, are these hard to fit?
No modifications are required, simply just remove and refit. You will also need to re-adjust your coilover height due to the drop incorporated into the knuckle and we recommend getting a wheel alignment.
GKTech design all our parts around fitting OEM parts also.
Do I need to do any other modifications to get the most from these knuckles?
You will see an improvement in feel just bolting these directly in, but will not see their full potential.
GKTech recommend to notch your lower control arms or at least modify your bump stops. This will allow more room of the tie rod end to travel inwards on lock, thus having more lock.
They also recommend bolt on rack spacers if you are running out of rack travel and or bolt on rack spacers, which still provide more rack travel but are mainly used to mitigate steering bind.
Keep in mind clearance is key, the more clearance everything has the more lock will be achievable, so you would need to ensure your swaybar, lower control arm and caster arm allow for this. GKTech make all high clearance versions of those parts which can be found on our website.